New Repeller Features:

• Refill Level-Based Sensor
• Replaceable Repeller Connection Cables (Pigtail)
• Cable Splitters
• Knockover Detection

Setting Up the System:

Setting up the system follows the same process as LIV 1.5. A few key points to note:

• The new cap on the repeller snaps on and off. If the cap unexpectedly comes off, you can easily snap it back into place.
• After enumeration, the cap will open. If there is an obstruction, the repeller will flash orange along with the operating color. Simply remove the obstruction and move the cap to close it. After a minute, the cap will automatically reopen.
• During cool-down (when the hub is powered off), repellers will display a blue chase until the heater cools down. Once this happens, the cap will close automatically.
• The terminator, which is located in the hub box, must be installed on the last repeller of the longest chain.  
• The screw caps, which come installed on the female pigtail of the repeller, should remain installed on the last repeller of the shorter chains (if the splitter is used).

New Error Colors:

• Tilt – Yellow / Blue Flash
• Knocked Over – Yellow / Blue Flash
• Cap Obstruction – Orange / Operating Color (blue is default) Flash

Other Important Notes:

• Please use the provided refills as they contain a float designed to work with the new repeller repeller refill life.
• Your system must be online to receive OTA updates.
• Do not change the reseller number.
• For support, please call 781-778-7797.